Target Group

Programmer, Commissioning Engineer, Service / Maintenance Engineer

Course Description / Objective

In this course you learn the handling of drive based Safety Functions. You can activate and parametrize the functions and therefore use benefits in comparison with a conventional safety technology. In this course the input signals are used from SIMATIC S7 F-CPU and from SINAMICS Terminal Modul TMF54

Course Content

- Fundamentals and directives of Machine Safety

- Safety Integrated Functions for SINAMICS S120

- Safety Integrated Basic Functions

- Safety Integrated Extended Functions via TM54F

- Safety Integrated Extended Functions via PROFIsafe

- SINAMICS S120 Safety Integrated and SIMOTION

- Practical exercises on the training kit

Registration Method

This course is on request. Please send us your request via Customer Service

Note

The minimum participants for per class is 6/8 paxs. If the course registration participants do not meet the minimum no of paxs, the class will be re-scheduled.

- Course registration is on first-come-first-served basis.

- Full payment has to be made before commencement of the course.

- If participant cancels the course after receiving the official course confirmation, the following cancellation fees apply :

> After confirmation is sent: 100% of order value

> Non Attendance after receiving an official course confirmation, no-show fee of 100% of the course fee will be imposed

If Siemens cancels a Training without offering a replacement, Siemens will provide full refund. If Siemens postpones a Training, the postponement is deemed accepted unless participant cancels the Training within 3 days of receiving the notice; in case of cancellation, Siemens will provide a full refund. Certificates will only be issued to participants with 75% attendance and course fee fully paid to Siemens. Please choose mode of payment when you register your course.

The purchase of or any transaction in relation to this Training is governed by the documents listed below in the following order of precedence:

1. the Terms and Conditions (https://www.e-pass.aae.siemens.cloud/UserManagement/TermsAndConditions.aspx);

2. the Training Supplemental Terms (https://www.siemens.com/sts-st-training); and

3. the Base Terms Singapore (https://www.siemens.com/sts-base-terms-sgp).