Target Group

Programmer, Commissioning Engineer, Service / Maintenance Engineer

Course Description / Objective

This training course encompasses the basics of the SINAMICS S120 drive system. It provides the technical knowledge required for startup, parameterization, drive optimization, and troubleshooting.

Practical exercises for reinforcing the knowledge gained are carried out on the SINAMICS S120 Training Case. On completion of the course, you will be able to implement automation solutions with the SINAMICS S120. You can carry out startup and optimization of the SINAMICS S120 quickly and effectively with skilful use of the STARTER commissioning tool.

In this way, you reduce engineering costs and minimize downtimes in your plant.

Course Content

- Design of the drive system and overview of documentation and service

- Startup and parameterization with the STARTER commissioning tool

- Diagnostics and troubleshooting

- Fundamentals of communication via PROFIBUS

- Software functions, closed-loop control and optimization of SERVO and VECTOR drives

- Startup of the integral basic positioner (EPOS)

- Practical exercises on the Training Kit

Registration Method

This course is on request. Please send us your request via Customer Service

Note

The minimum participants for per class is 6/8 paxs. If the course registration participants do not meet the minimum no of paxs, the class will be re-scheduled.

Course Fees available upon Request

- Course registration is on first-come-first-served basis.

- Full payment has to be made before commencement of the course.

- If participant cancels the course after receiving the official course confirmation, the following cancellation fees apply :

> Within 2 weeks prior to start date of course / after confirmation is sent : 100% of order value

> Non Attendance after receiving an official course confirmation : 100% of order value

The Center reserves the right to reschedule a course in any event, and in such cases, course participants can choose to withdraw without penalty.

Certificates will only be issued to participants with 75% attendance and course fee fully paid to Siemens.

Please choose mode of payment when you register your course