Target Group

Programmer, Commissioning Engineer, Service/Maintenance Engineer, Operator

Course Description / Objective

This course provides you with the basic knowledge necessary for configuring machine-specific and plant-specific human machine interface tasks with the SIMATIC WinCC flexible software. The course content is supported with practical exercises on a plant model.

This consists of an S7-300 automation system and human machine interface station. On completion of the course, you will be able to work efficiently with WinCC flexible and create an optimal configuration for any given requirement.

Confident in handling, you will be able to make effective use of the engineering phase.

Course Content

- System overview of SIMATIC WinCC flexible

- Creating the project

- Configuring connections to SIMATIC S7

- Graphics display creation for human machine interfacing

- User administration

- Message representation, message archiving, message configuring

- Variable archiving, configuring curves, representing curves

- Recipes

- Handling different human machine interface stations

Registration Method

SITRAIN only accept training registeration by e-PASS. Please register our training courses thru e-PASS. Course Fee listed is excluding 7% GST

Note

The minimum participants for per class is 6/8 paxs. If the course registration participants do not meet the minimum no of paxs, the class will be re-scheduled.

- Course registration is on first-come-first-served basis.

- Full payment has to be made before commencement of the course.

- If participant cancels the course after receiving the official course confirmation, the following cancellation fees apply :

> After confirmation is sent: 100% of order value

> Non Attendance after receiving an official course confirmation, no-show fee of 100% of the course fee will be imposed

If Siemens cancels a Training without offering a replacement, Siemens will provide full refund. If Siemens postpones a Training, the postponement is deemed accepted unless participant cancels the Training within 3 days of receiving the notice; in case of cancellation, Siemens will provide a full refund. Certificates will only be issued to participants with 75% attendance and course fee fully paid to Siemens. Please choose mode of payment when you register your course.

The purchase of or any transaction in relation to this Training is governed by the documents listed below in the following order of precedence:

1. the Terms and Conditions (https://www.e-pass.aae.siemens.cloud/UserManagement/TermsAndConditions.aspx);

2. the Training Supplemental Terms (https://www.siemens.com/sts-st-training); and

3. the Base Terms Singapore (https://www.siemens.com/sts-base-terms-sgp).