Target Group

This course is for PLC users who install or maintain automation systems and their application programs.

Course Description / Objective

Objectives. 

- Identify the components and performance characteristics of a PLC

- Install a PLC system, including the communication cabling and wiring of I/O

- Use the multiple address types to edit, reload, structure and run a program

- Document, test, and troubleshoot an HMI and Drive system within the control system

- Diagnose and fix hardware problems

- Utilize binary operations, timers, counters, comparators, and arithmetic operations for program modifications

- Integrate and troubleshoot an HMI and Drives within the control system

- Configure and troubleshoot Profibus DP nodes

Course Content

Topics. 

- Programmable Logic Controller (PLC) Overview

- Installation and maintenance of a PLC

- Hardware Configuration

- Hardware Commissioning

- Block Architecture and Program editors

- Symbols

- Binary operations

- Digital operations

- Introduction to HMI and Profibus DP

- Rewiring

- Introduction to Drive Systems

- Program documenting, saving, and archiving

Registration Method

SITRAIN only accept training registration by e-PASS. Please register our training courses thru e-PASS. Course Fee listed is VAT inclusive.

Note

The minimum participants for per class is 6/8 paxs. If the course registration participants do not meet the minimum no of paxs, the class will be re-scheduled.

- Course registration is on first-come-first-served basis.

- Full payment has to be made before commencement of the course.

- If participant cancels the course after receiving the official course confirmation, the following cancellation fees apply :

> After confirmation is sent: 100% of order value

> Non Attendance after receiving an official course confirmation, no-show fee of 100% of the course fee will be imposed

If Siemens cancels a Training without offering a replacement, Siemens will provide full refund. If Siemens postpones a Training, the postponement is deemed accepted unless participant cancels the Training within 3 days of receiving the notice; in case of cancellation, Siemens will provide a full refund. Certificates will only be issued to participants with 75% attendance and course fee fully paid to Siemens. Please choose mode of payment when you register your course.

The purchase of or any transaction in relation to this Training is governed by the documents listed below in the following order of precedence:

1. the Terms and Conditions (https://www.e-pass.aae.siemens.cloud/UserManagement/TermsAndConditions.aspx);

2. the Training Supplemental Terms (https://www.siemens.com/sts-st-training); and

3. the Base Terms Singapore (https://www.siemens.com/sts-base-terms-sgp).